UTPure7G Crash
I recently bought a new computer and decided to turn my old Pentium 4 into a dedicated server.
I tried installing UTPure7G, and the server crashes/shuts down when I try to boot it. As far as I'm concerned, I properly followed the instructions given in the readme.
If I remove the "serverpackages" lines (the 2 that contain the UTPure stuff), the server works fine. Any ideas?
Windows XP 32 bit, UT v436.
PS: This is a fresh install of UT, all I did was install the 436 patch prior to UTPure.
Last edited by Se7eN : 18th May, 2010 at 11:46 PM.
|